Weather Shield

I grew tired of working with a solderless breadboard and was worrying about the wires falling out of the makeshift  INSIDE portion of the DALLAS 1-wire weather station circuit I am working on (also the interface to other assorted 1-wire stuff outside) so I decided it was time for a PCB. The board contains a 2-wire BMP085 pressure sensor BOB and level converter… as well as a 1-wire temperature sensor.  This board contains the 1-wire bus connection (RJ45) to the outside world.

 

Here is the design I came up with:

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.